Sunsky 5v crimp polycarbonate roof panel in white opal model 136839 39 09 39 09.
Spacing for supports for fiber glass roof panels.
The width of metal panels will determine the rafter spacing.
Free delivery with 45 order.
Out of stock online.
Polycarbonate roof panel ridge cap in white opal model 109755 17 77 17 77.
Set your store to see local availability add to cart.
Beginning at the outside edge of your roof place each panel directly onto the purlins that are attached to the roof trusses.
Pre cut roof rafters to desired pitch and nail into position.
Solar grey polycarbonate roof panel ridge cap model 108654 17 77 17 77.
White opal polycarbonate roof panel wall connector model 109759 14 63 14 63.
To install corrugated roofing start by cutting your panels to length with an angle grinder.
Wider panels allow for greater spacing between rafters.
Use aluminum nails with neoprene washers and apply mastic to overlap of one corrugation.
Set your store to see local availability add to cart.
Free delivery with 45 order.
Free delivery with 45 order.
Pre drill holes and fasten side panels.
To determine how far apart to set rafters measure the width of the metal panel and then the width of the first hill and valley of the panel.
Next pre drill holes on the end and side ridges of the panels spacing the holes 6 to 8 inches apart.
Overlap roof panels one corrugation away from prevailing wind and nail to rafters starting from one end.
A metal roof must also allow for some overlap on each side of the panels which will reduce the effective width of the panel.
Adjust door construction to desired size.